When your Brivis ducted gas heater starts acting up, often the control board is the first place to look. This genuine Brivis NG-3 control board (BS80064183) is the direct replacement you need to get the system back online and keep homes warm during those chilly Aussie winters.

It’s a critical component for managing all operational aspects of your ducted gas heating unit, from ignition sequences to fan control. Swapping out a faulty board can sometimes be tricky, so make sure you’ve run through your diagnostic checks before condemning the old one.

Best For

• Licensed Gas Fitters & HVAC Technicians
• Heating System Service & Maintenance Teams
• Appliance Repair Specialists

Compatibility

This Brivis control board is specifically designed for Brivis NG-3 series ducted gas heaters. It's identified by Brivis Part Number 80064183 (also referred to as B064183). Always double-check your existing board's part number or your heater's model details against this product to ensure a perfect fit.

If you're running a different model, check fittings and specs before ordering.

Features

• Genuine Brivis spare part, ensuring exact fit and function.
• Direct replacement for Brivis NG-3 ducted gas heater systems.
• Identical to Brivis PN: 80064183 / B064183.
• Restores full control and safety functions to the heating unit.

What's in the Box

• 1 x Brivis NG-3 Control Board (BS80064183)

Using It on the Job

1. Isolate Power and Gas: Before starting any work, ensure the main power to the heater is switched off and locked out. Turn off the gas supply at the meter or appliance valve.
2. Access the Control Board: Carefully remove the heater's access panels to expose the existing control board.
3. Document Connections: Take photos of all wiring connections to the old board. Labeling wires can also save headaches later.
4. Replace the Board: Disconnect all wires and mounting screws from the old board, then install the new Brivis NG-3 control board, ensuring correct orientation.
5. Reconnect and Test: Reconnect all wiring exactly as documented. Restore power and gas. Follow the manufacturer's start-up procedure to test the heater's operation and confirm all functions are working correctly.

Limitations & Safety Notes

• Installation and servicing of gas appliances must be performed by a currently licensed gas fitter.
• Always refer to the Brivis manufacturer's service manual for specific model instructions and safety warnings.
• Ensure main power and gas supplies are isolated before commencing any work on the appliance.
• This board is only for specified Brivis NG-3 ducted gas heater models. Incorrect installation can cause damage or safety hazards.

Tradie Pro Tip

Before condemning the control board, always check simpler issues first, like blocked flues, faulty pressure switches, or dirty flame sensors. A quick resistance check on components might save you from replacing a perfectly good board.

Pair With

Pair this Brivis NG-3 control board with other genuine Brivis heating spares like gas valves, ignitors, or fan limit switches for a comprehensive repair. Consider new wall controllers or pressure switches if diagnosing intermittent faults.