[For 2-stroke gyro] Fly plate (4.5mm-418g) For 2-stroke gyro canopy. Cannot be installed on early/X mid-term engines (LSD type). A new fly plate is now available! No need to cut the protrusion of the normal fan! This is a plate to increase the weight of the outer rotor. A 20mm bolt under the neck is included. Since it is matched to the gyro PCD, it can also be used for dio systems with the same PCD. Made of steel. Trivalent plating will not rust. One piece weighs approximately 418g. (Old product 350g → new product 418g) The thickness is approximately 4.5mm. The fly plate has evolved again! Added role as a balance plate to reduce engine vibration! You can also enlarge the hole to increase the effect. Please use it as a setting part to suppress vibration caused by bore up, long crank, etc. When increasing the pressure in the cylinder by increasing the bore, etc., the stock crank does not have enough weight and the torque decreases due to pumping loss. By increasing the weight of the crankshaft, rotational inertia is improved and lost torque is regained. Also, you can achieve one more push at maximum speed. The genuine mounting bolts are too short to be used. A bolt 20mm below the neck is included, so please use that. Please be careful not to use bolts that are too long as this will damage the generator. If you are installing it on a stereo system, the fan may hit the fan cover, so you will need to shave off the fan cover or replace it with a thin fan. Items cannot be returned if the package has been opened. Note: Drive system setting is required! Note: The effect will not be achieved if you leave it on! Caution (Disclaimer) > Please read Items whose packaging has been opened cannot be returned. Note: Drive system setting is required! Note: The effect will not be achieved if you leave it on!


Manufacturer: ‎Tama Pit
Brand: ‎Tama Pit
Product size: ‎14 x 14 x 1 cm; 420 g
Manufacturer reference: ‎TAMA-FLYP-FBA
Product dimensions: Depth x Width x Height: ‎14 x 14 x 1 cm
Product weight: ‎420 g