Rigid cast cyberpunk armor! Buyer will need to trim flash edges and reinforce with epoxy putty if desired. Sections can be cut apart or mounted as one piece. 10" wide and 10" long.

Hot tip: Be sure to leave a little edge on the piece- holes can be drilled into the flat lip and sewn into fabric.

Price is for one shoulder piece.

- A plastic nipper, a rasp , sandpaper or a dremel can be used to refine edges. Here is a little more detailed info. Some craft/paint/kit building knowledge is recommended. I cannot provide build help beyond the info included here and in links provided.

- If you want any more info on buying from my shop please go through the FAQ/policy page in my shop: http://missmonster.myshopify.com/pages/f-a-q

- This is not a piece of safety equipment, this is a wearable prop. Please use common sense.

- Can be primed with any spray primer ( auto or otherwise) and painted with acrylics or whatever you prefer. Seal with clear coat to prevent scuffs after painting.

- This urethane is sensitive to heat. Please keep it out of direct sunlight as it can warp under it's own weight when hot.

-This can be heat shaped by immersing it in very hot water and shaping gently while soft. You can also use a heat gun or heat in the oven at around 175 degrees for a few minutes. Set the shape you want by immersing the warm mask in cold water or leaving on an upturned bowl or object to hold the shape while it cools.

- This is a project that should be attempted by adults or under adult supervision. Please read all safety warnings on materials you use. I am not responsible for any injuries sustained while customizing these masks.

- Do not use this as safety equipment or a welding mask or anything else but costuming. I am not responsible for injuries sustained through improper use of this prop.

By purchasing this you acknowledge that you have read and agree with the shop's policy page and have read and agree to comply with all of the information on this page.