FEATURES:

• NEW! Hybrid construction from wood and composite materials for specially reinforced fuselage and wings.  
• NEW! Patented quick assembly system for wings, stabilizer no tools require
• NEW! Patented quick assembly system for canopy. 
• NEW! Pre-installed blind nut on tip wing for night flight light system
• NEW! Counter balance on tip aileron for allow servo outboard move closer to inboard servo for lighter tip wing and crisp snap roll
• NEW! Fiberflass canopy frame. 
• NEW! Spinner painted special color scheme (additional option)
• Film covering applied over a Genuine German Oracover (Ultracote) base
• Highly prefabricated, experienced builders can have air ready in under a day
• Pre-installed hinges (glued and pinned)
• Internally mounted cowling – so no visible external screw expose
• Removable wings and stabs
• Laser engraved motor mounting position
• Easy canister installation due to open construction
• Pull push system for Rudder servo

Included hardware:

• Complete air frame with all basic accessories (such as carbon fibre main undercarriage, tail-gear assembly and wing-tubes as well as fibreglass control horns and wheel pants)
• “Spare” lower section cowl from transparent plastic – used to mark out correct location to cut the cowl for perfect fitting every time
• Pre-installed hinges and pre-mounted canopy
• Fuel tank and fuel tubing pre-prepared, fuel dot and breather valve
• Wheels, axels and wheel pants
• Pre-prepared pushrods with ball links
• Matching plain color carbon spinner 5”
• Baffles cooling for intake cowl to cylinder

Required hardware:

Motor: 80-120cc or equivalent electric

Servos: 7 high torque plus throttle // Uses x2 per aileron, x1 per elevator half and x1 or x2 on rudder using push-pull

Also requires all the usual accessories such as transmitter, receiver, propeller, batteries, powerbox, extension leads and possibly other small accessories.

Build information

COWL SIZE:

EXHAUST TUNNEL SIZE:

RUDDER HORNS AND PULL PULL LOCATION:

Extension wire lengths:

Throttle:
25cm

Each wing:
Inside aileron 30cm
Outside aileron 80cm
(to reach receiver direct)

Each elevator:
136cm

Each rudder servo:
136cm

CENTER OF GRAVITY:

215mm
Measured back from leading edge of the wing at the fuselage.

You will find a laser engraved C.G. emblem on the inside of the fuselage, located close to the wing tube, which also shows the exact location for Center of Gravity.

FULL Build manual: